Door Hinges / October 10, 2018 / Voleta Lemelin.
Alternatively if you can identify the brand name and model number of your hinge you can contact the manufacture directly to determine if theres a clip-on attachment is designed to work with your hinge style. If so they will be able to direct you to the nearest distributor in your area. If you determine that the upgrade is not available there is an alternative discussed in the later part of this article. Presently the additional clip-on parts cost from three to six dollars per piece. Most average sized kitchens have about twenty five cupboard doors. Calculating one slow-close clip per door puts us in the neighborhood of one hundred and twenty dollars ($120) to upgrade a standard sized kitchen to have this feature throughout.
If you have a three hinge door you can easily undo a single hinge plate at a time. If you have doors with just two hinges youll need to place a wedge under the door to take the weight off the hinge before you loosen it. 2) Once the plate is removed dip a couple cardboard matches into wood or white glue and put them into the hole. Then tighten the hinge screws and they should hold. 3) If the thought of shoving matches into the holes doesnt work for you use a golf tee or a sliver of wood instead. Cover these with glue and reinstall the hinge. Dont put the screw in the repaired hole yet. Allow the glue to dry then cut off any excess wood and then drill a pilot hole into it.
Removing a door with a two hole hinge is going to require two helpers so you might want to be sure you have a friend their to hold the door for you as you begin unscrewing it. Another choice you are going to have is whether or not that you want a removable pin or a fixed pin. This is going to depend more on your needs. A removable pin is going to make it easy for you to take the door off the hinges without unscrewing the hinge from the door jamb. You can easily begin shopping online and looking at all of the different designs that there are for door hinges you might actually be amazed at the choices.
You need to repeat this process a few times per year to ensure that everything is working properly. Start by checking for loose screws and change them where necessary. You can do this easily with a screwdriver. Sometimes we may also notice that the screws spin in place. This means that the screw holes are stripped and you will need to remove the screws. Simply dip a few matches inside the screw hole and the problem should now be gone. When dealing with creaks and squeaks you need to apply a couple of WD-40 squirts. Be sure to spray every joint so that it soaks in the middle.