Door Threshold / September 14, 2018 / Laure Lacharite.
They are known to flake and chip when exposed to sunlight and are often cited for creating more work than the protection provided. These low quality 2 or 3 mil. tapes often leave a sticky adhesive residue on thresholds as the adhesive used in the tapes softens in warm temperatures. Another option is to use fitted threshold protection made from molded plastic. The molded plastic threshold protectors are designed to protect the most common types of thresholds in residential or commercial construction. They are the most durable type of threshold protection and can be used for multiple projects.
Doors can be protected with temporary cardboard door protectors available from a variety of manufacturers. Several protectors are not only made from recycled cardboard but can be reused and recycled entirely again making these protectors truly green. The first protector to market and most popular is DoorGuard. It is a truly green product that uses recycled cardboard for the door protection with natural rubber bands for attachment. Another popular protector is the 1-2-3 Doorshield product. This protector is not recyclable as it uses plastic Velcro for the door attachment.
What is a high door threshold? This would be any doorway that has a threshold that you have to step over or a threshold that is higher than the surface you are walking on. These safety problems are obvious the high door thresholds are a trip hazard and for elderly people can be difficult to step over. Handicapped people in wheelchairs or motorized scooters wont be able to access these areas unless there is an alternative doorway that provides access for their wheelchairs. Usually the high door thresholds are located in a garage where someone has either made a mistake during new construction or simply figured that it would be easier to install the door a little higher and to remove the concrete foundation footing to install the door properly.
Ive learned by the hard way of experience that its necessary to remove old existing jambs carefully. If directly fastened to masonry with cut nails jambs removal may break out the cinderblock unless the jambs are cut into short manageable lengths. An out of level concrete threshold step can be ground flat by a concrete cutting subcontractor or the door threshold can be adjusted by unscrewing and repositioning in the jamb by the amount out of level. Any attached brickmold and casing must be removed from the jambs to make installation easier with shimming. Also brickmold will probably have to be ripped in width to fit the overall brick opening width and height.