Door Hinges / October 11, 2018 / Yvette Guerette
The new slow-close attachments only need to be added to one hinge per cabinet door unless you have large pantry doors. In such cases it is advisable to install two units per door. They will not work on just any European hinge though. You must have the correct straight-arm hinge brand and model number in order to be able to add the attachment to them. The hydraulic apparatus is sold as a separate piece from the hinge and clips on after the doors have been completely adjusted. To determine if the clip-on accessory is available for your existing hinge brand remove a hinge from your cupboard door and visit your local cupboard manufacturing supply company.
You need to repeat this process a few times per year to ensure that everything is working properly. Start by checking for loose screws and change them where necessary. You can do this easily with a screwdriver. Sometimes we may also notice that the screws spin in place. This means that the screw holes are stripped and you will need to remove the screws. Simply dip a few matches inside the screw hole and the problem should now be gone. When dealing with creaks and squeaks you need to apply a couple of WD-40 squirts. Be sure to spray every joint so that it soaks in the middle.
If you have a three hinge door you can easily undo a single hinge plate at a time. If you have doors with just two hinges youll need to place a wedge under the door to take the weight off the hinge before you loosen it. 2) Once the plate is removed dip a couple cardboard matches into wood or white glue and put them into the hole. Then tighten the hinge screws and they should hold. 3) If the thought of shoving matches into the holes doesnt work for you use a golf tee or a sliver of wood instead. Cover these with glue and reinstall the hinge. Dont put the screw in the repaired hole yet. Allow the glue to dry then cut off any excess wood and then drill a pilot hole into it.