Door Hinges / October 11, 2018 / Yvette Guerette
The new slow-close attachments only need to be added to one hinge per cabinet door unless you have large pantry doors. In such cases it is advisable to install two units per door. They will not work on just any European hinge though. You must have the correct straight-arm hinge brand and model number in order to be able to add the attachment to them. The hydraulic apparatus is sold as a separate piece from the hinge and clips on after the doors have been completely adjusted. To determine if the clip-on accessory is available for your existing hinge brand remove a hinge from your cupboard door and visit your local cupboard manufacturing supply company.
Amongst all the different door hinges out there one of the most common types is the butt hinge. It is two leaves with screw holes held together by a pin or a rod. Both leaves are recessed one end into the door and the other into the frame. When the door is closed all you see is the pin. With this type of door hinge it is easy to take the door down because all you have to do is remove the pin. Another type of door hinge that is similar to a butt hinge is the butterfly hinge. It also has two flaps or leaves held together by a pin but instead of being recessed into the door and frame they are mounted on the outside and when opened have the appearance of a butterfly in flight. These door hinges are highly decorative ranging in style from colonial to art deco and are used only on flush doors usually for cabinets. T-strap door hinges are more commonly seen on garage doors or boxes because they lift up rather than out.
If you have a three hinge door you can easily undo a single hinge plate at a time. If you have doors with just two hinges youll need to place a wedge under the door to take the weight off the hinge before you loosen it. 2) Once the plate is removed dip a couple cardboard matches into wood or white glue and put them into the hole. Then tighten the hinge screws and they should hold. 3) If the thought of shoving matches into the holes doesnt work for you use a golf tee or a sliver of wood instead. Cover these with glue and reinstall the hinge. Dont put the screw in the repaired hole yet. Allow the glue to dry then cut off any excess wood and then drill a pilot hole into it.