Door Hinges / October 11, 2018 / Yvette Guerette
Theres no need to waste money on new hinges when you can maintain and reuse your current ones! Nobody likes squeaky doors. Door hinges should always be maintained at least a couple of times per year if you want them to function properly. Hinges have also changed quite a lot over the years and they now come in a very wide array of finishes and materials not just steel brass and iron. Screws are usually the ones that fail first but if you own quality door hinges they will most likely never require any maintenance since theyre designed to never rust or tarnish. Depending on the situation the screws can be stressed a lot and will surely require to be replaced sooner or later. If you notice that the door hinges show signs of aging you should start the maintaining process by changing the screws.
One is attached to the top and one to the bottom. Portions of each are then folded over and recessed into the door and frame resulting in a concealed hinge. If open cabinets are a pet peeve of yours then the ever popular spring-loaded or self-closing hinge is for you. Built with a small spring inside the door automatically closes after it is opened. Youll never be annoyed by open cabinets again. No matter what you of cabinet door hinges you choose you still have to select a finish as well. From antique copper to polished chrome and everything in between the easiest route to take might be to match your cabinet knobs and drawer pulls.
If you have a three hinge door you can easily undo a single hinge plate at a time. If you have doors with just two hinges youll need to place a wedge under the door to take the weight off the hinge before you loosen it. 2) Once the plate is removed dip a couple cardboard matches into wood or white glue and put them into the hole. Then tighten the hinge screws and they should hold. 3) If the thought of shoving matches into the holes doesnt work for you use a golf tee or a sliver of wood instead. Cover these with glue and reinstall the hinge. Dont put the screw in the repaired hole yet. Allow the glue to dry then cut off any excess wood and then drill a pilot hole into it.