Door Threshold / September 18, 2018 / Pauline Francoeur
This calculation is based on the specification of the double glazing together with the profile design and dimensions to determine the insulation benefits of the door measured in U-values with the lower the value the better the insulation achieved. The minimum acceptable under current building regulations for replacement doors is a 1.8 U-value but some local authorities will insist on lower values particularly for new build extensions. 2. GLASS SIGHT LINES Another important consideration should be the sight line or width of door profiles between each panel of the folding sliding door as this will affect the visible glass area available when the door is in the closed position. Most bifold doors are designed with dedicated profiles to minimise these sightlines as much as possible but some timber and many upvc folding doors use wide chunky profiles that produce very broad sight lines in excess of 200mm wide that will ultimately spoil your view.
It is a truly green product that uses recycled cardboard for the door protection with natural rubber bands for attachment. Another popular protector is the 1-2-3 Doorshield product. This protector is not recyclable as it uses plastic Velcro for the door attachment. These large protectors are most often purchased in pallet quantities for use on many commercial projects however they are also available in smaller quantities as well. Doorjambs are quite often dented or scratched during construction. There are several types of protection available that snap onto the door casing and protect the jamb.
With the rough opening clean and prepped for the new door and jamb move the system into place as one with door hung on hinges. Temporarily shim the side jambs tight top and bottom ends in the rough opening. Temporary shims at the bottom hinge may also be required to straighten door sag. The top hinge will sag just be aware that you will compensate for it later with shims and a screw to snug it when the door is installed permanently. Use of a level isnt necessary just align the jambs flush with the interior plaster and shift shims to square the door in the jambs with even spacing reveal.