Door Threshold / September 12, 2018 / Ambra Daoust.
These large protectors are most often purchased in pallet quantities for use on many commercial projects however they are also available in smaller quantities as well. Doorjambs are quite often dented or scratched during construction. There are several types of protection available that snap onto the door casing and protect the jamb. These protectors can be made from molded plastic or cardboard. Pre-molded plastic protection works well for jambs with standard door casing widths. For larger jambs there are several wrap-around jamb protectors that work similarly but are not molded to an exact casing size.
Choosing the right bifold door for your project is an important decision and one that should not be taken purely based on cost alone. Your budget will naturally have an influence on your buying decision but there are other important factors that need serious consideration to ensure you are not disappointed with your purchase. Here are the top five points that are regarded by many as the most essential research when considering a bifold door purchase: 1. THERMAL PERFORMANCE Since most bifold door installations will be subject to compliance with building regulations it is important to check that the folding door you are about to buy will meet your local authoritys interpretation of current building regulations in terms of overall U-value performance.
Of course youre going to check the concrete threshold step for level. Carpenters never assume anything right? Measurement of the exterior brick opening overall height from threshold to lintel will be noted. Any further uncertainty about whether a house was built with masonry walls can be at least partly resolved by measuring the exterior brick opening overall width. A width measurement slightly off by about one-half inch from the nominal brick opening is a sure tip-off that youre going to be facing the direct fasten to masonry challenge. Adjust your installation estimate accordingly for some extra labor.
5. TOP HUNG OR BOTTOM ROLLING Some bifold doors are hung from the top to allow for a minimal threshold at floor level but with all the weight of the door being supported from the top a substantial upgrade of the lintel is normally required for strength and stability. Bottom rolling folding doors are a cost effective and popular alternative since the weight of the door is carried at ground level rather than suspended from the lintel. Whether you decide on an aluminium upvc or hardwood bifold door it is a major purchase for your project and one that should be carefully considered to ensure the very best value for your money.