Door Threshold / September 12, 2018 / Ambra Daoust.
The cost to protecting doors jambs and thresholds are well worth the small investment. The average cost for a cardboard door protector one cardboard jamb protector and tape for the threshold is less than 25.00 The cost to replace just a door alone can range from several hundred dollars to several thousand dollars. In addition many door protectors and jamb protectors are reusable so the long term cost for protection is even less. Experienced contractors recognize the importance of protecting the entry doors jambs and thresholds. Doing so is a great way to increase customer satisfaction and keep job site damage to a minimum.
3. SECURITY Most folding doors will feature a high security locking system but many still use face fixed or flag hinges that can pose a possible security issue and allow the hinges to be removed from the outside when the door is closed. Some upvc bifold doors may also use an exposed gearing system that is accessible from the outside of the door when the door is closed which can also pose a possible security threat. You can eliminate these potential security problems by ensuring you choose a folding door that has fully concealed gearing and hinge fixings.
When youre satisfied that the door system is in the correct position drill through the thickest part of the hinge jamb with a regular drill at the hinges areas and then further drill into the cinderblock with a hammer drill. Drill the strike jamb in the same corresponding locations with the middle drilling positioned between the strike and deadbolt mortises. Countersink jambs holes to flush the masonry screw heads. It may be necessary to remove the door from the hinges for this step just remember to check the indexed jambs alignment to be sure nothing has moved. Remove shims and then remove door system from the rough opening. This must be done to install the plastic expansion sleeves into the holes drilled into the cinderblock.
I believe installation direct to masonry is the height of challenge for an entry door where skills and patience for a carpenter are truly tested. You really only have one chance to get it right - screw hole mistakes in the cinderblock dont allow for incremental jambs adjustments. Here is where carpentry meets art you must think and be creative. So the satisfaction of a properly installed door in this case becomes at least for me a real thrill. On the initial site visit to measure up the door youre going to tap on the walls to see if they are drywall or plaster.