Door Threshold / September 17, 2018 / Martine Letourneau.
This calculation is based on the specification of the double glazing together with the profile design and dimensions to determine the insulation benefits of the door measured in U-values with the lower the value the better the insulation achieved. The minimum acceptable under current building regulations for replacement doors is a 1.8 U-value but some local authorities will insist on lower values particularly for new build extensions. 2. GLASS SIGHT LINES Another important consideration should be the sight line or width of door profiles between each panel of the folding sliding door as this will affect the visible glass area available when the door is in the closed position. Most bifold doors are designed with dedicated profiles to minimise these sightlines as much as possible but some timber and many upvc folding doors use wide chunky profiles that produce very broad sight lines in excess of 200mm wide that will ultimately spoil your view.
For the Greeks a door was not simply a way to enter a building but a holy place itself worthy of the highest respect." Keeping doors jambs and thresholds looking great while a home is under construction or remodeling is important and is now easier than ever. During construction contractors will pass through the doorway with materials and equipment needed for the construction project. Each pass risks scratching or denting the home entryway. Temporary protection should be in place prior to the start of construction and should include protection for all the aspects of the entryway.
Ive learned by the hard way of experience that its necessary to remove old existing jambs carefully. If directly fastened to masonry with cut nails jambs removal may break out the cinderblock unless the jambs are cut into short manageable lengths. An out of level concrete threshold step can be ground flat by a concrete cutting subcontractor or the door threshold can be adjusted by unscrewing and repositioning in the jamb by the amount out of level. Any attached brickmold and casing must be removed from the jambs to make installation easier with shimming. Also brickmold will probably have to be ripped in width to fit the overall brick opening width and height.
These protectors can be made from molded plastic or cardboard. Pre-molded plastic protection works well for jambs with standard door casing widths. For larger jambs there are several wrap-around jamb protectors that work similarly but are not molded to an exact casing size. These reusable protectors provide excellent protection however they are the most expensive jamb protectors in the market. Less expensive cardboard protectors wrap around jambs in a similar fashion and cost considerably less than their plastic counterparts. These are available from a wide range of manufacturers can be purchased online or in construction supply stores as well.