Door Hinges / October 11, 2018 / Yvette Guerette.
What do begin to fail are the screws that hold the door hinges on the door and the frame. The stresses and strains of everyday openings begin to loosen the screws. This is particularly true on heavier doors that are either left open a lot or bear lots of traffic. At least twice a year you want to go through your entire home inspecting all the door hinges. If you find an loose screws simply tighten them with a screwdriver. If the screws in the door hinges spin in their place and wont tighten into the wood it means the holes are stripped. When this happens do the following: 1) Remove the screws on that particular hinge.
Cabinet door hinges are one of the biggest afterthoughts in home design but they often get the biggest workout in the home. Nary an hour goes by that someone isnt opening a cabinet somewhere in the home whether its in the kitchen pantry bathroom or hallway. Most simply make do with the hinges that came with the cabinet. Only when they begin to squeak and sway in complaint about their endless exercise do we give thought to changing them. And only then do we only change the offending hinge that has failed to do its duty tightly and quietly. But changing out hinges can yield some exciting results in the home particularly when they are visible hinges.
The pin can be outfitted with balls or finials for a decorative touch. Similar to the butt hinge but used only on flush doors; doors that rest within the frame are butterfly hinges. These cabinet door hinges are also constructed with two flaps with screw holes held together by a pin. The difference is these hinges are mounted on the outside of the door and frame giving your cabinet a decorative touch. They are available in several styles to suit your taste ranging from colonial to art deco and more. Pivot hinges are made for overlay doors which are doors that rest over the door frame.
You need to repeat this process a few times per year to ensure that everything is working properly. Start by checking for loose screws and change them where necessary. You can do this easily with a screwdriver. Sometimes we may also notice that the screws spin in place. This means that the screw holes are stripped and you will need to remove the screws. Simply dip a few matches inside the screw hole and the problem should now be gone. When dealing with creaks and squeaks you need to apply a couple of WD-40 squirts. Be sure to spray every joint so that it soaks in the middle.