Door Threshold / September 16, 2018 / Marphisa Duffet
In addition many door protectors and jamb protectors are reusable so the long term cost for protection is even less. The front entryway including the door jambs and threshold is the focal point of your clients home. It sets the tone and expectation for the rest of the home and it can add or detract curb appeal. Entryways have been important dating as far back to the Greeks. According to Jesse Nevins of Coastal Carolina University "To ancient Greeks doors were considered sacred and surrounded with superstition. So much so that doors and the comprising parts had their own deities.
4. THRESHOLDS Although a flush threshold is the most popular option especially for internal bifold doors this may not always be practical in some cases and a conventional raised threshold will need to be used. It is important to note that the height of these can vary considerably with some upvc bifold door thresholds exceeding 125mm. Such a high step-over threshold may create an accessibility issue for children and the older generation. The latest bifold door designs offer raised thresholds designed to minimise the trip hazard with some offering thresholds as low as 50mm high.
Tightly wedged shims will allow you to operate the door carefully. Open and close to check the door touching the weather stripping evenly top to bottom for any possible jambs twist. Adjust as necessary even though jambs may not flush with plaster top to bottom. A good carpenter wont assume the original door was installed correctly right? Check the brickmold reveal you should have consistent and even measurements side to side and top to bottom. Its unusual to have brick out of plumb to any great extent. Adjust shims again as necessary. Index the jambs in the rough opening and the shims to jambs with pencil for reference when installing the system permanently. Remember you only have one chance to get this installation right so be patient - you will be rewarded with a satisfying outcome.