Door Threshold / September 16, 2018 / Marphisa Duffet.
With the rough opening clean and prepped for the new door and jamb move the system into place as one with door hung on hinges. Temporarily shim the side jambs tight top and bottom ends in the rough opening. Temporary shims at the bottom hinge may also be required to straighten door sag. The top hinge will sag just be aware that you will compensate for it later with shims and a screw to snug it when the door is installed permanently. Use of a level isnt necessary just align the jambs flush with the interior plaster and shift shims to square the door in the jambs with even spacing reveal.
These protectors can be made from molded plastic or cardboard. Pre-molded plastic protection works well for jambs with standard door casing widths. For larger jambs there are several wrap-around jamb protectors that work similarly but are not molded to an exact casing size. These reusable protectors provide excellent protection however they are the most expensive jamb protectors in the market. Less expensive cardboard protectors wrap around jambs in a similar fashion and cost considerably less than their plastic counterparts. These are available from a wide range of manufacturers can be purchased online or in construction supply stores as well.
This protection screws into a wood subflooring to hold it in place and thus cannot be used on sliding doors installed over cement slabs which are commonly used on the west coast. Another option that does work for protecting sliding doors installed on cement slabs is impact-resistant U-board protection. It is a thick heavy weight compressed paper protection that is made from recycled material and is completely reusable. The U-board is placed over the tracks while the door is open and protects sliding door tracks from dirt and grime. As with the plastic protector the Sill Pro keeps the sliding tracks clean and protects the tracks of the door from damage that can interfere with the working operations of the door.
During construction contractors will pass through the doorway with materials and equipment needed for the construction project. Each pass risks scratching or denting the home entryway. Temporary protection should be in place prior to the start of construction and should include protection for all the aspects of the entryway. Doors can be protected with temporary cardboard door protectors available from a variety of manufacturers. Several protectors are not only made from recycled cardboard but can be reused and recycled entirely again making these protectors truly green. The first protector to market and most popular is DoorGuard.