Door Threshold / September 18, 2018 / Pauline Francoeur.
Most entry door thresholds are manufactured from metal or a combination of metal and wood. Metal thresholds often have black anodized coatings that are easily scratched or dented. Wood thresholds can be stained scratched and dented as well. Some manufacturers have now manufactured plastic covers to protect their exact thresholds dimensions and include the covers with the complete door unit. There are other pre-molded protectors available from online suppliers of temporary protection products. There are also a variety of tapes that can be used for threshold protection.
This calculation is based on the specification of the double glazing together with the profile design and dimensions to determine the insulation benefits of the door measured in U-values with the lower the value the better the insulation achieved. The minimum acceptable under current building regulations for replacement doors is a 1.8 U-value but some local authorities will insist on lower values particularly for new build extensions. 2. GLASS SIGHT LINES Another important consideration should be the sight line or width of door profiles between each panel of the folding sliding door as this will affect the visible glass area available when the door is in the closed position. Most bifold doors are designed with dedicated profiles to minimise these sightlines as much as possible but some timber and many upvc folding doors use wide chunky profiles that produce very broad sight lines in excess of 200mm wide that will ultimately spoil your view.
Tightly wedged shims will allow you to operate the door carefully. Open and close to check the door touching the weather stripping evenly top to bottom for any possible jambs twist. Adjust as necessary even though jambs may not flush with plaster top to bottom. A good carpenter wont assume the original door was installed correctly right? Check the brickmold reveal you should have consistent and even measurements side to side and top to bottom. Its unusual to have brick out of plumb to any great extent. Adjust shims again as necessary. Index the jambs in the rough opening and the shims to jambs with pencil for reference when installing the system permanently. Remember you only have one chance to get this installation right so be patient - you will be rewarded with a satisfying outcome.
Of course youre going to check the concrete threshold step for level. Carpenters never assume anything right? Measurement of the exterior brick opening overall height from threshold to lintel will be noted. Any further uncertainty about whether a house was built with masonry walls can be at least partly resolved by measuring the exterior brick opening overall width. A width measurement slightly off by about one-half inch from the nominal brick opening is a sure tip-off that youre going to be facing the direct fasten to masonry challenge. Adjust your installation estimate accordingly for some extra labor.