Door Hinges / September 29, 2018 / Talon Gregoire.
But when door hinges become a bit unhinged from years of use they can not only cause doors to squeak stick or rub but allow heat to escape and cold to enter. Maintaining your door hinges is a simple process something you can do once or twice a year. And it will keep your hinges working properly for years to come. Unlike the old days when door hinges were made of iron brass or steel todays hinges come in an array of materials and finishes. Thanks to modern manufacturing techniques most of these finishes are maintenance free. Left alone they wont tarnish rust or fail over time.
The pin can be outfitted with balls or finials for a decorative touch. Similar to the butt hinge but used only on flush doors; doors that rest within the frame are butterfly hinges. These cabinet door hinges are also constructed with two flaps with screw holes held together by a pin. The difference is these hinges are mounted on the outside of the door and frame giving your cabinet a decorative touch. They are available in several styles to suit your taste ranging from colonial to art deco and more. Pivot hinges are made for overlay doors which are doors that rest over the door frame.
Too weak of hinges and youll always be straightening the door. This can become maddening very quickly. If you have concealed hinges and want to move to surface mounted cabinet hinges chances are good that youll want to go with either semi-concealed hinges where only the frame wing is visible (the door part goes on the back side of the cabinet door) overlay hinges or inset hinges. It just depends on the type cabinet doors you have. One good hint: Before you redo all your hinges buy several different styles and finishes and put them on them in various parts of the kitchen.
If you have a three hinge door you can easily undo a single hinge plate at a time. If you have doors with just two hinges youll need to place a wedge under the door to take the weight off the hinge before you loosen it. 2) Once the plate is removed dip a couple cardboard matches into wood or white glue and put them into the hole. Then tighten the hinge screws and they should hold. 3) If the thought of shoving matches into the holes doesnt work for you use a golf tee or a sliver of wood instead. Cover these with glue and reinstall the hinge. Dont put the screw in the repaired hole yet. Allow the glue to dry then cut off any excess wood and then drill a pilot hole into it.