Door Hinges / October 11, 2018 / Yvette Guerette.
What do begin to fail are the screws that hold the door hinges on the door and the frame. The stresses and strains of everyday openings begin to loosen the screws. This is particularly true on heavier doors that are either left open a lot or bear lots of traffic. At least twice a year you want to go through your entire home inspecting all the door hinges. If you find an loose screws simply tighten them with a screwdriver. If the screws in the door hinges spin in their place and wont tighten into the wood it means the holes are stripped. When this happens do the following: 1) Remove the screws on that particular hinge.
Its a fairly easy task to change the hinges on your door but it is somewhat time consuming. This is something that will dramatically change the look of your door and it is something that you definitely want to consider changing. Alright lets go over the different types of hinges that are available. Hinges have holes in them and they usually come in two different amounts of holes - two holes or three holes. The three hole hinges are going to increase the stability of the door. So if your door is heavy than you will want a three holed hinge over the two holed hinge.
Removing a door with a two hole hinge is going to require two helpers so you might want to be sure you have a friend their to hold the door for you as you begin unscrewing it. Another choice you are going to have is whether or not that you want a removable pin or a fixed pin. This is going to depend more on your needs. A removable pin is going to make it easy for you to take the door off the hinges without unscrewing the hinge from the door jamb. You can easily begin shopping online and looking at all of the different designs that there are for door hinges you might actually be amazed at the choices.
You need to repeat this process a few times per year to ensure that everything is working properly. Start by checking for loose screws and change them where necessary. You can do this easily with a screwdriver. Sometimes we may also notice that the screws spin in place. This means that the screw holes are stripped and you will need to remove the screws. Simply dip a few matches inside the screw hole and the problem should now be gone. When dealing with creaks and squeaks you need to apply a couple of WD-40 squirts. Be sure to spray every joint so that it soaks in the middle.