Door Hinges / September 27, 2018 / Martine Letourneau.
What do begin to fail are the screws that hold the door hinges on the door and the frame. The stresses and strains of everyday openings begin to loosen the screws. This is particularly true on heavier doors that are either left open a lot or bear lots of traffic. At least twice a year you want to go through your entire home inspecting all the door hinges. If you find an loose screws simply tighten them with a screwdriver. If the screws in the door hinges spin in their place and wont tighten into the wood it means the holes are stripped. When this happens do the following: 1) Remove the screws on that particular hinge.
You need to repeat this process a few times per year to ensure that everything is working properly. Start by checking for loose screws and change them where necessary. You can do this easily with a screwdriver. Sometimes we may also notice that the screws spin in place. This means that the screw holes are stripped and you will need to remove the screws. Simply dip a few matches inside the screw hole and the problem should now be gone. When dealing with creaks and squeaks you need to apply a couple of WD-40 squirts. Be sure to spray every joint so that it soaks in the middle.
Alternatively if you can identify the brand name and model number of your hinge you can contact the manufacture directly to determine if theres a clip-on attachment is designed to work with your hinge style. If so they will be able to direct you to the nearest distributor in your area. If you determine that the upgrade is not available there is an alternative discussed in the later part of this article. Presently the additional clip-on parts cost from three to six dollars per piece. Most average sized kitchens have about twenty five cupboard doors. Calculating one slow-close clip per door puts us in the neighborhood of one hundred and twenty dollars ($120) to upgrade a standard sized kitchen to have this feature throughout.
These were large tapestries that were hanging in front of a big hole in the wall. They would block the entryway to a room and had to be pushed out of the way every time you wanted to go in or out. Going further back in time were large rocks that would have to be rolled in front of the door and then rolled away or pieces of wood that were pulled in front of the doorway and pushed back every time you wanted to go in and out. While it did the general job of a door it was a very inconvenient and very heavy way to go. These images illustrate why we should be thankful that someone finally came up with the great idea to make a more easy to use access to a room namely a door on door hinges.