Door Threshold / September 16, 2018 / Marphisa Duffet.
UV protective tape has chemicals in both the tape and adhesive that block UV rays and make the tape resistant to both sunlight and heat. It can be used in both hot and cold climates without the worry of adhesive transfer resulting in a quick and clean removal upon project completion. Although more expensive than other tapes UV protective tape is very cost effective when the costs of clean up or repainting of entry thresholds are considered. Blue masking tape and blue sill tapes are the most common tapes for protecting thresholds. These low cost tapes work for short term protection only in areas of low heat or sunlight.
New jambs allow for air-tight vinyl weather stripping and adjustable thresholds with vinyl door bottom sweeps. Low maintenance fiberglass or metal doors are sandwiched with foam insulation. And doors with windows come with thermal glass. Installing a new door in an existing older home has become a highly desired remodeling upgrade. These days installing a pre-hung entry door system (including jambs) to new wood stick frame construction is generally pretty straight forward; you can just nail or preferably screw through the jambs to the framing studs behind. If adjustments are necessary just pull the nail or back out the screw re-align the jamb using builders shims and try again.
Then re-assemble door system and re-shim into the indexed positions in the rough opening. At last now fasten jambs to the cinderblock with the masonry screws using shims at each screw location. Fine tune screw adjustments by wedging the shims to get the reveals around the door even. Adjust top and bottom jamb shims as necessary. Open and close door to check touching the weather stripping evenly top to bottom for any possible jambs twist. Some slight remaining jambs twist can be adjusted by persuading the jambs with a block and a hammer. Be careful. Now nail the shims permanently in position with a pneumatic nail gun shooting squarely into the cinderblock. Dont worry the nails should sink into the cinderblock as long as they are the proper length and are nailed squarely and firmly.
Garage door insulation is essential with wooden doors as you cannot allow any water to get in to penetrate the wood. You must have a high quality threshold sealant to help prevent rotting and severe damage to your door. The great thing about using wood though is that if it does endure wear and tear over the years it can be reconditioned without the need to replace the entire door. The most used type of door however is the steel door. You will see this one on most garages across America. Steel is extremely strong and robust and is impervious to rust. This gives you great peace of mind that the door will last for many years to come.